How to set up tubeless tyres

What you will need:
240ml Tubeless Sealant
Tubeless Conversion System
0
Amount needed per tyre:
40ml = 700C x 18-23
60ml = 26" / 700C x 28-35
80ml = 27.5" / 650B
120ml = 29" / DH
0
Check out our video on adding tubeless sealant using our 1L bottle! If using 240ml and filling through the valve, please following instructions below.
0

 

STEP 1
 Ensure the rim of the wheel is clean and dry before adding new tape. To fit rim tape, start by fitting a small amount of the tape next and pressing it down tightly to avoid creases by using your thumb or finger. Continue the entire way around the rim in small segments ensuring there are no air gaps and overlap the tape.
0
STEP 2
Locate the valve hole and pierce using a sharp tool so the tape is ready for the value to be inserted. You will now need your Tubeless valve, remove the valve cap and lockring, then insert the value and place through the hole, secure in place and reinstall the lockring and cap.
0
STEP 3
Refit the tyre, being careful not to damage the tape. Inflate tyre to create air-tight fit using a tubeless inflator, ensuring that the tyre bead locks into place. You will hear a loud popping noise once the bead has locked or snapped into place.
0
STEP 4
Release any existing air in your tyres. Shake Tubeless Sealant well before use. Unscrew the integrated valve core remover (cap) leaving the black smart valve connector in place and remove the valve core from the valve. 
0
STEP 5
Fully extend and attach the flexible hose to the valve using the smart valve connector and squeeze the required volume of tubeless sealant (see recommendations above) into your tyre.  Put the valve core back in.
0
STEP 6
Pump your tyres up as normal. Then give the wheels a spin to make sure the tubeless sealant is evenly distributed and ready to prevent a puncture.
0
Enjoy the ride!